Safety data sheet for Sulfur

CAS 7704-34-9

This is the free preview of a draft SDS for Sulfur — Sections 1, 2 and 9, generated from the sources named below. The full 16-section draft, with your own company in Section 1, is $5 per document.

Typically documented by: Garden fungicide, rubber, soap.

Draft safety data sheet — preview

Sections 1, 2, 9 of 16

CAS number
7704-34-9
Molecular formula
S
Molecular weight
32.07 g/mol
Signal word
Warning

Hazard classification

  • GHS07 — Exclamation mark — irritant
  • H315: Causes skin irritation.

Section 1 — Identification

1.1 Product identifier

Product identifier: Sulfur

Chemical name (IUPAC): sulfur

CAS number: 7704-34-9

PubChem CID reference: 5362487

Synonyms: alpha-Sulfur; Brimstone; elemental sulfur; Flour sulfur; Flowers of sulfur; Precipitated sulfur; Sublimed sulfur; Sulfur, elemental; sulphur; Sulphur [ISO]

Section 2 — Hazards Identification

2.1 Classification of the substance or mixture

Classification basis: OSHA 29 CFR 1910.1200 Appendix A, aligned to the GHS Rev. 7 hazard classes this sheet resolves: Skin Irrit. 2.

Classification: Skin Irritation, Category 2 (Skin Irrit. 2) [H315]

Second-source corroboration: every hazard class above is corroborated by EU harmonised classification (CLP Annex VI).

2.2 Label elements

Signal word: Warning

GHS pictograms: GHS07 (Exclamation)

Hazard statement: H315: Causes skin irritation.

Precautionary statement: P280: Wear protective gloves, protective clothing, eye protection and face protection.

Precautionary statement: P264: Wash hands thoroughly after handling.

Precautionary statement: P302+P352: IF ON SKIN: Wash with plenty of water.

Precautionary statement: P362+P364: Take off contaminated clothing and wash it before reuse.

Precautionary statement: P332+P313: IF SKIN irritation occurs: Get medical advice/attention.

2.3 Other hazards

Other hazards: Combustible dust. May form combustible dust concentrations in air (fine powder dispersed in air near an ignition source can explode).

Section 9 — Physical and Chemical Properties

9.1 Information on basic physical and chemical properties

Physical form: Solid

Appearance: Light yellow solid

Odor: Pure sulfur is odorless, but traces of hydrocarbon impurity may impart an oily and/or rotten egg odor

Boiling point: 444.6°C (832°F)

Melting point: 115.2°C (239°F) (monoclinic)

Flash point: 207°C (405°F) closed cup

Density: 2.07 g/cm³

Vapor pressure: 5.3 × 10⁻⁴ Pa at 30.4°C

Water solubility: Insoluble in water

Log Pow (log Kow): 0.5 (calculated)

Vapor density: 7.84 (air = 1) at 470°C

Auto-ignition temperature: 232°C (450°F)

Viscosity: Not applicable (solid at 20°C)

Not stated in the sourced records: Lower explosive limit, Upper explosive limit, pH.

Where each value came from

Odor — Hazardous Substances Data Bank (HSDB)
U.S. Coast Guard, Department of Transportation. CHRIS - Hazardous Chemical Data. Volume II. Washington, D.C.: U.S. Government Printing Office, 1984-5
View the record
Boiling point — Hazardous Substances Data Bank (HSDB)
Lide, D.R. CRC Handbook of Chemistry and Physics 88th Edition 2007-2008. CRC Press, Taylor & Francis, Boca Raton, FL 2007, p. 4-92
View the record
Melting point — Hazardous Substances Data Bank (HSDB)
Same reference as boiling point above.
View the record
Flash point — Hazardous Substances Data Bank (HSDB)
National Fire Protection Association; Fire Protection Guide to Hazardous Materials. 14th Edition, Quincy, MA 2010, p. 325-104
View the record
Density — Hazardous Substances Data Bank (HSDB)
Same reference as boiling point above.
View the record
Vapor pressure — Hazardous Substances Data Bank (HSDB)
Ashford, R.D. Ashford's Dictionary of Industrial Chemicals. London, England: Wavelength Publications Ltd., 1994, p. 934
View the record
Water solubility — Hazardous Substances Data Bank (HSDB)
Same reference as boiling point above.
View the record
Vapor density — Hazardous Substances Data Bank (HSDB)
Nehb W, Vydra K; Ullmann's Encyclopedia of Industrial Chemistry. 7th ed. (1999-2011). New York, NY: John Wiley & Sons; Sulfur. Online Posting Date: 15 Dec 2006
View the record
Auto-ignition temperature — Hazardous Substances Data Bank (HSDB)
Same reference as flash point above.
View the record

A value with no row here was assembled from more than one record, so no single record is credited for it. The draft you buy carries this table as an appendix covering all 16 sections.

Sources

  • Hazardous Substances Data Bank (HSDB)
  • PubChem — GHS classification
  • PubChem — compound record
  • PubChem — names and identifiers
  • PubChem — regulatory information
  • PubChem — toxicity data
  • PubChem — transport information

Sections 1.3 and 1.4 are withheld here because the supplier and emergency contact blocks carry your own company details in the draft you buy. Every draft needs review by a competent person before it is issued.

Measured values for Sulfur, and where each one comes from

15 measured values for 10 properties, read from 1 public database. On 2 properties the records differ. Each reading is shown with its own record. Follow any linked record to read the value at its source.

Boiling point

1 record

Used with vapour pressure to judge how readily the substance reaches the air you breathe.

Melting point

2 records, 95 to 107 °C

Fixes the physical state at handling temperature, which the label and the transport class depend on.

95.3 °C /(Sulfur rhombic transforms to monoclinic)/; 115.21 °C /Sulfur (monoclinic)/
Hazardous Substances Data Bank (HSDB)
MP: 106.8 °C /gamma-Sulfur/
Hazardous Substances Data Bank (HSDB)

Flash point

1 record

The lowest temperature at which the liquid gives off enough vapour to ignite. It decides the GHS flammable liquid category.

405 °F (207 °C) (Closed cup)
Hazardous Substances Data Bank (HSDB)

Auto-ignition temperature

1 record

The temperature at which the substance ignites with no spark or flame. It sets safe surface and process temperatures.

Explosive limits

2 records differ

The vapour concentration range in air that will burn. Below the lower limit and above the upper limit it will not.

Upper explosive limit: 1400 g/cu m, lower explosive limit: 35 g/cu m
Hazardous Substances Data Bank (HSDB)
...Explosion risk above 260 °F
Hazardous Substances Data Bank (HSDB)

Vapour pressure

1 record

The higher it is, the faster the substance evaporates into the workplace air at room temperature.

3.95X10-6 mm Hg at 30.4 °C
Hazardous Substances Data Bank (HSDB)

Vapour density

1 record

Above 1 the vapour sinks and collects in pits, sumps and low enclosed spaces.

Density of vapor/density of air, 470 °C: 7.837
Hazardous Substances Data Bank (HSDB)

Density

1 record

Needed to convert between mass and volume on the label, in transport papers and in a spill estimate.

2.07 g/cu cm (Sulfur (rhombic)/; 2.00 (Sulfur (monoclinic)/
Hazardous Substances Data Bank (HSDB)

Solubility

4 records, each a different case

Determines spill behaviour, the right extinguishing media and the correct first-aid rinse.

For more Solubility (Complete) data for Sulfur, Elemental (13 total), please visit the HSDB record page
Hazardous Substances Data Bank (HSDB)
Insoluble in water; slightly soluble in ethanol, benzene, ethyl ether; soluble in carbon disulfide /Sulfur (rhombic)/
Hazardous Substances Data Bank (HSDB)
Insoluble in water; slightly soluble in ethanol, benzene, ethyl ether; soluble in carbon disulfide /Sulfur (monoclinic)/
Hazardous Substances Data Bank (HSDB)
Soluble in carbon disulfide, benzene, warm aniline and carbon tetrachloride, and liquid ammonia
Hazardous Substances Data Bank (HSDB)

Odour

1 record

Odour is a warning property only. Many substances are hazardous well below the concentration you can smell.

Pure sulfur is odorless, but traces of hydrocarbon impurity may impart an oily and/or rotten egg odor
Hazardous Substances Data Bank (HSDB)

These are the public records read for Sulfur, published here unchanged except that computer-generated digit strings are shortened (28.520000000000003 shows as 28.52). Where two records disagree, the draft you buy states the value and names the record behind it, so a reviewer can see what was chosen. Every draft needs review by a competent person before it is issued.

Get the full draft SDS for Sulfur

The draft covers all 16 sections under OSHA 29 CFR 1910.1200 and GHS Rev. 7, or the CLP EC 1272/2008 layout for the EU. Each draft arrives as an editable Word .docx with an appendix naming the source of each value, in about 60 seconds. $5 per document, no account.

Intake

Safety Data Sheet (SDS) — $5 per document

Confirm the compound and the document, then continue to checkout. Every document is delivered as a draft for professional review.

Safety Data Sheet (SDS)US OSHA HazCom format · editable .docx draft

A CAS number or a chemical name.

Standard known chemicals only. A mixture or an unlisted compound stops before checkout and routes to the free mixture classifier (a declared formula can be bought there as a $5 EU-format draft) or Custom SDS on Pro.

We deliver the draft to this address, normally within 60 seconds.

Branding and formatOptional — default branding, US format

Used to white-label the draft. Leave blank for default branding.

Format

Guest checkout through Stripe. Every document is a draft for review by a qualified EHS professional before you put it to use.